I finally made it to the machine room. I set the temperature. Fuse went out. I replaced the fuse.
I clicked on the water collection machine. It said temperature setting wrong. I clicked on the side panel of the middle machine and when I clicked on the panel nothing happened. Did I miss something?
Thanks,
Susan

Hi Susan,

The side panel that you should open is the one closest to the water collection machine. The panel should go away and reveal the frame puzzle that you should calibrate. Try looking for a hotspot close to the bottom to remove that panel.

Good luck!
MaG

Hi MaG,
I found a hotspot on the right side of the center rock processing machine. A panel opened but nothing happened. Was this the wrong one?
Susan

Linds, if the message says "Temperature Setting Wrong", you won't see the Callibration panel yet - you first need to set the temperature setting. So far, you've replaced the fuse and now have the machine working again, but the machine needs to be set to the appropriate temperature setting. Do you remember what that is? Let me know if you need a hint.

Mike.