I'm at Mason's monitor & opened component design 5.5. I can see the 4 layers squares at the left, but I don't see Ryan's design at right. Can someone tell me what I missed. Also, the walkthrough says to start at bottom layer; would that be layer # 4? Thanks Judy

Ryan should have given you the plan before doing this puzzle. Talk to her again.

Edited - error.

Bottom layer is #1. It corresponds to the location of the frame to the layers on the center structure.

Well, I went back to talk to Ryan, but all Nancy will talk about is being locked in the lab with no air. I think I may have to start the game over again.

Have you checked the large Tesla coil already?
Check your To do list and see what else needs to be done.

I'll check my to do list again, but if it does not work, I must have mucked something up along the way. If so, I'll start over. I don't mind doing this,because it's not the first time. LOL I started in master, but had trouble with the colored paper puzzle & switched to amateur. Oh well, I'll know this game inside & out by the time I'm finished. Thanks MaG.

If the To Do list is not seen; you might still be in Master mode.

Isn't the bottom layer 1???
You build it from the bottom up, 1 to 4.

Yes - Thanks LadyLinda. I better edit so no mistake be done.

Woo Hoo!!! I started the game over & this time I got the plan from Ryan, built the 3D image & got the part not a blob. For the life of me, I don't know why I didn't get it the first time; unless I didn't pick it up from the yellow stool Ryan put it on? Oh well, fun game, but more difficult than some of the other ND's. Thanks MaG, if you didn't tell me about the plan, I would have been going around in circles.

Wonderful! That's very good. Have fun.