Can't find where to find the electron or black marble to put on the morpher to get the copper(1) -ions. Where do I find the black marble?I only have clear marble and blue marble. Wish I had paid more attention to science. I am not science inclined. Diane

Hi Diane,

The only place I saw on the wt of sable to get glass beads are in that drawer with the copper wire at the Ni area. This must be where you got the others. I might be way off since I haven/t played the game. If the Chemicus veterans are out there, let's wait and I'll try to contact sable also.

MaG

after you put the crbon oxide 2 in the left tray go in for a closse up of the screen with the red button and the black beads should be right there on the left of the screen.

Hi sami -

You don't use the "marbles" in the morpher. They are glass.

Put the Cu(II) oxide in, then go close-up. You can find an "electron" right there, to move onto the molecule model. Add an electron to the outer ring and press the morph-button to create Cu(I) oxide.

OH Help again I'm stuck. At the water pools where you climb down the ladder . I can see the door to the right of me but it's still part way under water and I can't open it. I go back to the control room but the water pump is as far down as I can get it. What am I doing wrong?

Diane, I'm just working from the walkthrough here, but this is what it says to do if the pool is not empty: SPOILER
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
* (If 1st pool is full, go to Ti in control room and switch the 2 water pumps back so the left one is almost empty).

As far as I know I have switched the water pumps but the water only goes half way down the door. Maybe there is another pump somewhere? OH sable!!!!!!!!HELP Diane

Here's a picture of what the control panel should look like when the settings are correct. Notice the right-hand tank nearly empty, and most important, the Yellow indicator, bottom center.

To get this setting, you must have installed the metal pipe you found, and rotated it to the backmost position.