Still Life 2-- Stuck in Lasers

Posted by: MissLeopard83

Still Life 2-- Stuck in Lasers - 01/02/13 04:47 PM

Can someone please help me? I've gotten through the laser part in Still Life 2 but, where Vic says to turn off the blinking box (to the left of computer monitor in game), I cannot get a hot spot. Could someone please send a saved game so I don't have to start over again? Thanks!
Posted by: Rushes

Re: Still Life -- Stuck in Lasers - 01/02/13 05:08 PM

Hi MissLeopard, welcome to GameBoomers.

The saved game is on the way to you.
Posted by: MissLeopard83

Re: Still Life -- Stuck in Lasers - 01/02/13 05:15 PM

You are a lifesaver! Thank you!

----------------

Rushes, I think you sent me a saved game for Still Life (the original). I realized that I meant "Still Life 2" and did not write it. I'm stuck in SL2. Sorry! :(
Posted by: Rushes

Re: Still Life -- Stuck in Lasers - 01/02/13 05:25 PM

Argh, unfortunately I don't have any saves for Still Life 2. Let's wait and see if anyone else does.
Posted by: MissLeopard83

Re: Still Life -- Stuck in Lasers - 01/02/13 05:26 PM

That's OK. I realized my error after I received your email. Sorry!
Posted by: Rushes

Re: Still Life -- Stuck in Lasers - 01/03/13 09:18 AM

No-one seems to have a save handy -- if you're still having problems, perhaps you could go back to an earlier save and replay this part through, that might unstick you.

Be sure not to miss any of the steps. Here's the extract from MaG's walkthrough:

Place the reflector on the stand at the middle of the green laser's path.

Yellow laser: Turn the stand that is the source of the yellow lasers at top left. The yellow lasers now go through the green laser path.
This bends the yellow lasers to the laser concentrator at left. See that the color of the concentrated laser beam is now yellow-green.
Green laser: Turn the right stand that sends out green laser to point at another concentrator. See that the emitted light from the concentrator is red-green.
Click on the blinking red light on the box at bottom left. It is emitting a signal. Click to turn that red light off.

Other concentrators and blinking red light box: Go to the box left of the computer monitor and turn it off. That turns the gas tank on the ceiling and the lasers off.

luck
Posted by: MissLeopard83

Re: Still Life 2-- Stuck in Lasers - 01/03/13 05:14 PM

I meant to post last night. I figured it out and finished the game this morning. I realized what I was doing wrong. I didn't realize there were two switches -- one by the chemical shelf and the other by the computer. Once I turned the one off by the chemicals, the hot spot turned up by the computer. cool
Posted by: Rushes

Re: Still Life 2-- Stuck in Lasers - 01/04/13 09:38 AM

Glad you found what the problem was. :)